User's Manual

Tele Eye
RX
User
Guide Page 55
Setup
Tele
Eye RX for Broadband or Narrowband
Internet Connection with Dynamic IP
Step14: Configure the network setting for
Tele
Eye RX
transmitter and your PC if necessary, such as
router/gateway port mapping (select
router/gateway IP as IP provided by your ISP
and the transmitter IP as IP provided by the
router/gateway), firewall, etc. (Please refers to
the manual of your router/gateway.)
Step15: Run WX-30 software at any network PC. (For
details of WX-30 software installation, please
refer to WX-30 Software Guide)
Step 16: Press [Connect] icon to pop up the
[Connect Window]. For example, type and
select the following setting :
Broadband Connection :
Phone/IP :
www.your_site.your_company.teleeye.net
Connect Using: TCP/IP Broadband
Password: 000000
OR
Narrowband Connection :
Phone/IP :
www.your_site.your_company.teleeye.net
Connect Using: TCP/IP Narrowband
Password: 000000
Step 17: Press [Connect] icon to connect
your PC and the transmitter. The video appears
on the WX-30 if success. Otherwise, the
[Warning] board will pop up and show you
failure message. For failure case, please press
[Connect]
icon to check that the
connection setting is valid or not.