Instruction manual

-5-
(Mounting CONT’D)
SS651-CH and LCS653-CH CONTROL HEADS
The control head is designed for
mounting in an easily accessible
location such as under the dash, in
the overhead console, or in a center
console.
- Choose a mounting location
convenient to the operator and away
from any air bag deployment areas.
- Be sure to choose a location that has at least two inches of depth to
accommodate the control head and cables.
- Consider wire routing and access to connections
when selecting location as well.
- Using the switch panel unit itself as a template, mark
the location of the two mounting holes to be drilled.
Be sure to check for obstructions behind the
mounting hole locations.
- Drill the two mounting holes and secure the switch
panel using appropriate hardware (not supplied).
SS651MT-CH CONTROL HEAD
The SS651MT-CH weatherproof control head is
designed for use in locations that may be
exposed to water.
- Choose a mounting location convenient to the
operator and away from any air bag
deployment areas.
- Be sure to choose a location that has at least two inches of space on the right
side to accommodate the cable exiting the side of the control head.
- Consider wire routing when selecting location as well.
- The SS651MT-CH can be mounted
through the two holes in the rear
cover. To gain access to the
mounting holes, detach the rear
cover by removing the four screws
affixing it to the control head.
- Secure the switch panel using
appropriate hardware (not
supplied).
SS651MT-CH
SS651
-
CH
L
CS653
-
CH
Mounting Holes
Rear of SS651MT-CH
Remove these four screws