Instruction manual

-1-
Specifications
Input Voltage 10 - 16 VDC (negative ground)
Audio Input Current 8 Amps @ 13.6 VDC (100W speaker)
Standby Current Enable wire off 0mA
Backlighting off: 8 mA
Output Power 105 WATTS RMS MAX. (15.0 VDC - single 100W speaker)
Siren Frequency 675Hz - 5kHz
High Voltage Protection > 16 VDC will cause siren output to cease, resume at normal
< 10 VDC will cause siren output to cease, resume at normal
Short Circuit Current 50 AMPS (supply circuit must be capable of supplying this)
Operating Temperature -15°F (-30°C) to +140°F (60°C)
Size 2” High, 6” Wide, 5-3/4” Deep
Boxed Weight 3.4 lbs.
SERIAL NO: DIP SWITCH OPTIONS
PURCHASE DATE: _____ Negative Aux. Polarity
DEALER: _____ Hands Free Enabled
INSTALLATION DATE:
INSTALLER:
Model and serial number located on the bottom of the amplifier unit
The SS650 AND LCS652 Remote Siren Amplifiers are designed for single 100W speaker
use. They come standard with the amplifier unit and control head (switch panel) all in one
unit. The primary operating modes are Wail, Yelp, Standby, Manual, and Horn. Both the
Horn and the Manual Control function will override all other functions, and can be utilized at
any time via a rocker switch.
The siren amplifier has been designed with several protection features to provide exceptional
field service. Excessively high voltage detection will disable the siren output to protect both
the amplifier and the speaker. A fused input provides safety against reverse polarity.
Speaker protection shuts down the output if the speaker output becomes electrically shorted.
CAUTION: These protection features will not guard against overloading the outputs.
Installation Information
General Description