User's Manual

5
Setup
The Pressure Scout needs to be set up for correct operation before being fielded. The configurable items
include:
- Network selection
- Check-in period selection
- Modbus Slave ID setting
- Optional alarm thresholds and scaling
All settings are made using the SignalFire Toolkit PC application and a USB-serial programming cable available
from SignalFire.
Using the SignalFire Toolkit
The SignalFire Toolkit application can be downloaded at www.signal-fire.com/customer. After installation,
launch the software and the main toolkit window will open:
Select the COM port associated with the Pressure Scout and click “Auto-Detect Device on COM Port.” This will
open the device configuration window, where all device settings can be configured.
WARNING: Perform the steps in this section (Setup) in a safe location only.
SignalFire Telemetry
Rev 1.1