User`s guide

Signamax 

 065-7726SPOE / 065-7726SPOE-FP 24-Port 10/100BaseT/TX
PoE Managed Switch User Manual
Publication date: February 2010
Revision A1.0
10
2. Installation
2-1. Starting 065-7726SPOEUp
This section will give users a quick start for:
- Hardware and Cable Installation
- Management Station Installation
- Software booting and configuration
2-1-1. Hardware and Cable Installation
At the beginning, please do first:
⇒ Wear a grounding device to avoid the damage from electrostatic discharge
•
••
• Installing Optional SFP Fiber Transceivers to the L2 Managed Switch
with PoE
Note: If you have no modules, please skip this section.
•
••
• Connecting the SFP Module to the Chassis:
The optional SFP modules are hot swappable, so you can plug or unplug it before or after
powering on.
1. Verify that the SFP module is the right model and conforms to the
chassis
2. Slide the module along the slot. Also be sure that the module is properly seated
against the slot socket/connector
3. Install the media cable for network connection
4. Repeat the above steps, as needed, for each module to be installed into
slot(s)
5. Have the power ON after the above procedures are done
Fig. 2
-
1
Installation of
O
ptional
SFP
Fiber
T
ransceiver