Bolt on Bed Frame Assembly Guide

USE PROPER SECTIONS TO ASSEMBLE

I:i ['I'&~ .:.:i ['I'~i I FRAM ES

");~' ~ IMPORTANT ~

-Q =- I Swing ?ut ~II cross rails as 4J/"" Slip plastic caps on

~"""<"'1<:;"""" shown In diagram. Insert ends of side rails.

glides into legs.

Use this section if you have a standard 4-leg

Bed Frame. (Twin, Full or Queen bedding).

0 Select proper pair

of Keyhole Slots for Side

size of bedding to Rail

be used. Side Rail

Use these

Keyhole Use these V

slots for Ke

yhole

. TWIN Use these

A Overlap cross rails and slots for Keyhole

V slide Shoulder Rivets FULL slots for

into Keyhole Slots. QUEEN

Shoulder A

~Rivet~ V -::::;:::: Pull cross rails OUTWARD

Q) . ~ ~ so that Shoulder Rivets lock

0 . 0 ~ in Keyhole Slots.

C::;:).~

0\...,.,.:) After completing Step number 3, insert

of Cross Arms to lock them into place.

Use this section if you have a Queen Size

Bed Frame with Center Support, which

includes a Center Cross Rail with Leg.

After Bed Frame has Clip (0) Side Rail (C)

been assembled in . '"

Queen position,

[see Section above],

swing the single Center

angle iron Center r:)pport

Support (A) under .

Side rails (C), so

that clips (D) slide

over the top of both ~enter s.upport goes from

side rails directly side to side

in the center. G~~::::~~~~:f1::::::::~~~i~

SideRa ..~:t:i~~::::,::::::::~ :;.,