Installation Sheet

2
INSTALLATION
STEP 1: ATTACHING THE FEET
1. Carefully lay the tub upside down on towels or other
padding so that the bottom of the tub is facing up.
2. Each dovetail bolt will slide into one of the four
slotted mounting pods as shown.
3. Match each tub foot with its corresponding pod, as
shown below. If the letters on your tub and feet do not
match, lay the feet out on the floor and check to see if
all feet are the same size. If one pair of feet are slightly
shorter than the second pair, then the shorter pair are
meant to mount on the side of the tub containing the
drain hole.
Important: If the feet are not installed in their correct
locations, the tub will not properly drain. Use a level to
ensure that the inside of the tub is sloped towards the
drain before moving on to tub installation.
4. Slide the foot down over the dovetail bolt. Thread a
flat washer, locking washer and nut onto the bolt (in that
order).
CAST IRON CLAWFOOT TUB
Cast Iron Clawfoot Tub Installation Instructions
Mounting
Pod
D
D