Installation Sheet

1Double Offset Tub Supply Installation Instructions

TOOLS AND MATERIALS:

INSTALLATION

1. Slide the bell anges (I) over the copper pipes at the nished oor.

2. Place thread sealant or plumber's tape on the copper pipes. Attach the

straight stop valves (F) with the provided compression nuts (H) and ferrules

(G).

3. Slide the remaining compression nuts (D) onto the supply tubes.

4. Place the supply tubes (C) and ferrules (E) into the straight stop valves and

tighten the compression nuts.

5. Close the straight stop valves and briey turn on the main water supply to

check for leaks. If leakage occurs, tighten the connections with an adjustable

wrench as necessary. If problems persist, contact Customer Service.

6. Install the tub faucet according to the faucet installation instructions.

DOUBLE OFFSET TUB SUPPLY

INSTALLATION INSTRUCTIONS

Before you begin, read the installation instructions below. Observe all local plumbing and building codes. For the following

installation instructions for your new tub supplies it is assumed that the water supply lines are in place and directly

accessible for installation.

Unpack and inspect for any shipping damages. If you nd any damages, do not install. Contact Customer Service at

1-866-855-2284. If you need assistance while installing your tub supplies, call our Customer Service number.

We recommend consulting a professional if you are unfamiliar with installing bathroom xtures and plumbing. Signature

Hardware accepts no liability for any damages to the oor, walls, plumbing or personal injury during installation.

PARTS LIST:

A. (2) Rubber Cone Washer

E. (2) Ferrule B. (2) Slip Nut

G. (2) Ferrule

C. (2) Supply Tube

H. (2) Compression Nut

D. (2) Compression Nut

I. (2) Bell Flange

Adjustable Wrench Plumber’s Tape

Damp Cloth Thread Sealant

F. (2) Straight Stop Valve