Installation Sheet

2Shannon Widespread Faucet Installation Instructions

SHANNON WIDESPREAD FAUCET

3. Set the decorative escutcheon over the center

faucet hole, then set the spout into the hole.

4. From beneath the countertop, slide the metal

washer back onto the threaded shank. Hand tighten

the lock nut, then ﬁnish tightening using an adjustable

wrench.

Important: The opening on the metal washer should

face the back of the faucet so that it will line up with the

hole in the spout that is reserved for the drain’s lift rod.

5. Reattach the T-connector to the end of the thread-

ed shank by hand tightening. Apply plumber’s tape or

thread sealant to the threads before tightening. Ensure

that the inlets of the T-connector and pointing to the

left and right.

6. The faucet’s valve stems are labeled by colored

plastic washers – blue for ‘cold’ and red for ‘hot.’ On the

‘cold’ valve stem, loosen the lock nut to its furthest

point at the bottom of the stem

lock nut