Manualshelf

Installation Sheet

ManualsBrandsSignature Hardware ManualsShop All Signature HardwareSignature Hardware Reproduction 1.2 GPM Double Tap Bathroom Faucet with Cross Handles
12345
REPRODUCTION NON-MIXING SINK FAUCET
INSTALLATION
3. From below, slide one of the provided rubber washers
onto the threaded shank followed by one of the metal
washers. The textured side of the metal washer should
face down. Secure the spout to the surface using one of
the plastic lock nuts. Hand tighten firmly.
4. Repeat steps 2 and 3 to install the ‘cold’ spout into
the right-side mounting hole that has been prepared.
1. Ensure that the water supply below your sink is
completely shut off by turning the shutoff valves all the
way to the right.
Tip: Place a small bucket below your workspace to
catch any water that may drip during the installation
process.
2. Insert the faucet spout labeled as ‘hot’ into the
left-side mounting hole that has been prepared.
2Reproduction Non-Mixing Sink Faucet Installation Instructions
OFF