Installation Sheet

REPRODUCTION NON-MIXING SINK FAUCET
7. Proceed to the drain installation. Once complete, turn
the faucet on for approximately 60 seconds to remove
any dust or loose sediment from the water lines. Ensure
that there are no leaks, and that both hot and cold water
are running properly. Turn off once testing is complete.
6. Once installation is complete, turn the main water
supply back on from underneath your sink. Check for
any leaks underneath.
3Reproduction Non-Mixing Sink Faucet Installation Instructions
5. Use braided water lines to connect each spout to the
main water supply. Use the provided brass nuts and
cone washers to make the connections if needed. Be
careful not to overtighten the water lines.
ON
60 sec