Installation Sheet

1Corner Shower Curtain Rod Installation Instructions

INSTRUCTIONS

Unpack and inspect the product for any

shipping damages. If you ﬁnd damages, do not

install. Contact Customer Service at

1.866.855.2284. If you need assistance or have

questions while installing your shower rod

contact Customer Service.

We recommend consulting a professional if

you are unfamiliar with installing bathroom

ﬁxtures. Signature Hardware accepts no liability

for any damage to the walls or ceiling, or for

personal injury during installation.

TOOLS AND MATERIALS:

Read entire shower rod installation Instructions.

Observe all local building and safety codes. For

the following installation instructions it is

assumed that any old ﬁxtures have been

removed and any repairs to the wall have

been completed.

BEFORE INSTALLING INSTALLATION

CORNER SHOWER CURTAIN ROD

Pencil

Tape Measure

Level

Screwdriver

Drill

Hammer

Hacksaw

¼" Drill Bit

1. Lay the rod sections on the ﬂoor. Assemble the rod with the

connector piece.

2. Verify that the rod sections are the proper length for your

installation. If not, trim with a hacksaw.

3. Hold the wall brackets up at the desired mounting height.

PAGE 1
CORNER SHOWER CURTAIN ROD BEFORE INSTALLING INSTALLATION Read entire shower rod installation Instructions. Observe all local building and safety codes. For the following installation instructions it is assumed that any old ﬁxtures have been removed and any repairs to the wall have been completed. 1. Lay the rod sections on the ﬂoor. Assemble the rod with the connector piece. INSTRUCTIONS Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install.
PAGE 2
CORNER SHOWER CURTAIN ROD INSTALLATION 4. Mark the placement of the mounting holes. Use a tape measure and level to make sure that your pencil marks are lined up properly on each wall. 7. Attach the rod and brackets to the wall with the mounting hardware provided. 5. Drill pilot holes for the wall anchors. 8. Slide the 1" loop onto the curved section of the rod. Note: If there is a stud in your mounting location, use wood screws to attach the wall brackets. 6.
PAGE 3
CORNER SHOWER CURTAIN ROD INSTALLATION 10. Mark the location of the celling support and measure the distance between the ceiling and the rod. If necessary, trim the ceiling support to the proper length with your hacksaw. 13. Drill pilot holes for the anchors and tap the anchors in with a hammer. 11. Once the support is ready, insert it into the 1" loop. Attach the ceiling bracket to the other end and tighten the set screws. 14. Attach the ceiling bracket. 12.