Installation Sheet

Shelf Bracket Installation Instructions 1

1. Attach your shelf bracket(s) to the bottom of the shelf that

you are mounting using the provided screws. Ensure that each

bracket is properly aligned before attaching.

Important: Not all shelf materials can be drilled into. If your

shelf is made of a fragile material, use a proper adhesive.

SHELF BRACKET INSTALLATION

INSTRUCTIONS

TOOLS AND MATERIALS:

Unpack and inspect the product for shipping

damage. If any damage is found, contact

Customer Relations at 1.866.855.2284.

BEFORE INSTALLING INSTALLATION

We recommend consulting a professional if

you are unfamiliar with installing this type of

hardware. Signature Hardware accepts no

liability for any damage to the bracket, shelf,

wall, or personal injury during installation.

Observe all local building codes.

Screwdriver

Drill

Level

Pencil

Stud Finder

2. Locate where you wish to hang your shelf. Use a stud ﬁnder

to locate a stud behind your wall.

drywall stud

stud

ﬁnder

GETTING STARTED

Ensure that you have gathered all the

required materials that are needed for

installation.

PAGE 1
SHELF BRACKET INSTALLATION BEFORE INSTALLING INSTALLATION We recommend consulting a professional if you are unfamiliar with installing this type of hardware. Signature Hardware accepts no liability for any damage to the bracket, shelf, wall, or personal injury during installation. Observe all local building codes. 1. Attach your shelf bracket(s) to the bottom of the shelf that you are mounting using the provided screws. Ensure that each bracket is properly aligned before attaching.
PAGE 2
SHELF BRACKET INSTALLATION 3. While holding the shelf against the wall, adjust it until it is level. Once the shelf is properly aligned, use a pencil to mark the location of each mounting hole on the wall. Have someone assist you if needed. 5. Attach the bracket(s) to the wall using the provided mounting screws. Be careful not to overtighten, which could strip or break the screw. 4. Drill small pilot holes in the marked locations from step 3.