Owners Manual

FLUSHING WATER LINES (CONTINUED)
5. Turn on the hot and cold faucet taps to release any
pressure and excess water. Turn off.
6. With a wrench, remove water lines underneath the
faucet, placing the ends in a bucket.
7. Open the shut-off valve or water main and let water
flow into the bucket for 15 seconds.
8. Close the shut-off valve or main supply, then reattach
the water lines to the faucet.
9. Reopen the valves to restore water to the faucet and
check for leaks.
1. Place a towel at the base of the faucet and remove the
faucet aerator. If using pliers, place a rag around the
aerator to protect the finish.
2. Turn on the cold and hot water, letting the faucet run
for 10-15 seconds.
3. Rinse out the aerator, carefully noting the placement of
washers inside. Replace the aerator and check water
flow. If there is no improvement, continue to Step 4.
4. Close the shut-off valves or turn off your home's water
main, twisting the valves clockwise as far as possible.
Aerator
Set Screw
Water Line Attachment