Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom Hardware6-1/4" Wall Mounted Towel Ring - Round Base

1Towel Holder Installation Instructions

INSTRUCTIONS

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install. Contact

Customer Service at 1-866-855-2284. If you need

assistance or have questions while installing your

towel holder, contact Customer Service.

We recommend anchoring any ﬁxtures that will bear

weight to wall studs or solid wood blocking. If the

studs in your bathroom do not line up to the

mounting location for your towel holder, wood

blocking can be installed between the studs

using standard 2 x 4’s. We recommend consulting a

professional if you are unfamiliar with this type of

installation.

Because wall construction and materials vary from

home to home, Signature Hardware does not

provide mounting hardware for all of our towel

holders. The appropriate mounting hardware can be

purchased from your local hardware store.

We recommend consulting a professional if you are

unfamiliar with installing bathroom ﬁxtures. Signature

Hardware accepts no liability for any damage to the

ﬂoor, walls or for personal injury during installation.

Read entire Towel Holder Installation Instructions.

Observe all local building and safety codes.

TOOLS AND MATERIALS:

Pencil

BEFORE INSTALLING TOWEL BAR

TOWEL HOLDER

1. If the mounting brackets and towel bar arrive assembled,

disassemble by removing the set screws with an Allen

wrench (provided) or screwdriver.

2. Determine the installation location and mark the wall through

each of the mounting holes in the mounting brackets.

3. Drill the screw holes with the appropriate drill bit for the wall

surface or material.

4. Attach the mounting brackets to the wall with the mounting

hardware. Use your level and tape measure to ensure

your brackets are perfectly straight and in the proper position.

5. Attach the towel bar to the bar holders and place the bar

holders on the mounting brackets. The set screws should

be on the underside of the towel holder.

6. Secure by tightening the set screws with your Allen wrench

(provided) or screwdriver.

TOWEL RING

1. Determine the installation location and mark the wall through

each of the mounting holes in the mounting bracket. The

mounting holes should be aligned vertically.

2. Drill the screw holes with the appropriate drill bit for the wall

surface or material.

3. Attach the mounting bracket to the wall with the mounting

hardware.

4. Place the towel ring on the mounting bracket. The set screw

should be on the underside of the towel ring.

Note: If the set screw is already in place, you may need to loosen

the screw when installing your towel ring so that the mounting

bracket and towel ring ﬁt together properly.

5. Secure by tightening the set screws with your Allen wrench

(provided) or screwdriver.

Level

Screwdriver

Drill

Tape Measure Stud Finder

Summary of content (2 pages)

PAGE 1
TOWEL HOLDER BEFORE INSTALLING TOWEL BAR Read entire Towel Holder Installation Instructions. Observe all local building and safety codes. 1. If the mounting brackets and towel bar arrive assembled, disassemble by removing the set screws with an Allen wrench (provided) or screwdriver. INSTRUCTIONS Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install. Contact Customer Service at 1-866-855-2284.
PAGE 2
TOWEL RACK OR SHELF 1. Assemble by attaching any shelves with the hardware provided. This is done by inserting the assembly screws through the back of the wall brackets and into the shelves. Tighten the assembly screws with the provided Allen wrench. A B C D E F 2. Determine the installation location and mark the wall through each of the mounting holes in the wall bracket. Use your level and tape measure to ensure your shelf is perfectly straight and in the proper position. 3.