Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom FaucetsSignature Hardware Ballantine 1.2 GPM Wall Mounted Vessel Widespread Bathroom Faucet with Lever Handles and Pop-Up Drain Assembly

1Ballantine Wall-Mount Faucet Installation Instructions

BALANTINE WALL-MOUNT FAUCET INSTALLATION

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing bathroom ﬁxtures and

plumbing. Signature Hardware accepts no liability for

any damage to the ﬂoor, walls, plumbing, or personal

injury during installation.

For the following installation instructions for your new

Wall-Mount Faucet, it is assumed that any old ﬁxtures

have been removed and the water supply lines have

been relocated to the proper installation location.

Unpack and inspect the item for damage. If any

damage is found, contact our

Customer Relations team at 1-866-855-2284.

Ensure that you have gathered all of the required

materials that are needed for the installation.

Plumber’s Tape

Shut oﬀ the main water supply where the new faucet

is being installed.

Drill

Thread Sealant

Tape Measure Level

Hex Wrench

Pipe Clamps

SKU(s): 911574, 911575

Summary of content (5 pages)

PAGE 1
SKU(s): 911574, 911575 BALANTINE WALL-MOUNT FAUCET INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing bathroom ﬁxtures and plumbing. Signature Hardware accepts no liability for any damage to the ﬂoor, walls, plumbing, or personal injury during installation.
PAGE 2
BALANTINE WALL-MOUNT FAUCET INSTALLATION INSTALLATION 1. Prepare for installation by installing wood blocking between the two studs where the faucet will mount. 3. Attach the main water lines to the valve. Apply thread sealant or plumber’s tape to the threaded connection to ensure a watertight seal. Important: Take into consideration the thickness of your ﬁnished wall materials.
PAGE 3
BALANTINE WALL-MOUNT FAUCET INSTALLATION 4. Once your ﬁnished wall has been completed, slide the decorative ring onto the base of the spout. Attach the spout to the installed valve body. Once in place, tighten the set screw underneath to secure. 6. Attach the hot and cold handles to the valve stems, as shown. Ensure that the hot handle is on the left, and the cold is on the right. Decorative Ring Cold Handle Hot Handle 5. Attach the handle escutcheons to the installed valve body.
PAGE 4
BALANTINE WALL-MOUNT FAUCET INSTALLATION DRAIN INSTALLATION 1. Dissasemble the drain assembly and lay the parts aside, in the same order they were removed. See the illustration below as a reference if needed. 2. Apply plumber’s tape to the threading on the tailpiece, then reattach the tail piece to the pop-up drain ﬂange. Pop-Up Drain Flange Flat Rubber Gasket Tapered Rubber Gasket Plastic Friction Washer Lock Nut 3.
PAGE 5
BALANTINE WALL-MOUNT FAUCET INSTALLATION 4. Insert the drain ﬂange and tailpiece through the top of your sink’s drain hole. 6. Thread the lock nut onto the drain ﬂange. Hand tighten until secure, then ﬁnish tightening with a basin wrench once the drain is properly aligned. Important: Be careful not to overtighten, which could crack a porcelain sink or stone countertop. COUNTERTOP COUNTERTOP COUNTERTOP COUNTERTOP 5.