Installation Sheet

ManualsBrandsSignature Hardware ManualsDeadboltIron Carpenter's Rim Lock Set with Knobs and 4-5/8" Backset - Left Handing

1Rim Lock Set Installation Instructions

INSTRUCTIONS

Unpack and inspect the product for any

shipping damages. If you ﬁnd damages, do not

install. Contact Customer Service at

1.866.855.2284. If you need assistance or have

questions while installing your lock set contact

Customer Service.

We recommend consulting a professional if

you are unfamiliar with installing hardware

ﬁxtures. Signature Hardware accepts no liability

for any damage to the door or door frame, or for

personal injury during installation.

TOOLS AND MATERIALS:

Pencil

Read the following installation and care

instructions.Observe all local plumbing,

building, and electrical codes. Install your

tub on an adequately supported and level

ﬁnished ﬂoor.

BEFORE INSTALLING IMPORTANT INFORMATION

These locks are not designed for security. They should not be

used on exterior doors unless they are supplemented by

an auxiliary deadbolt or other device.

INSTALLATION

1. Mark the position of the lock set on the inside of the door.

Decide where you will place the lock set on your door. Hold

the larger piece of the lock body against the inside of the

door at the desired location and lightly trace around it with a

pencil. Mark the location of the holes for the fasteners. Then

hold the smaller piece of the lock body in corresponding

position on the door frame or wall and mark the holes with a

pencil.

2. Measure the location of the spindle and the keyhole.

Transfer these measurements to the door, and mark their

locations with a pencil.

3. Drill a hole to accommodate the spindle. The hole should

be large enough to allow the spindle to turn freely.

4. Use a drill and chisel to create a keyhole in the door. Drill a

hole at the top and bottom of the keyhole you marked in Step

2. Use a chisel to remove any wood between the two holes.

Note: The key has to be able to pass through the entire door to reach the

lock body, so test your key to make sure it ﬁts before proceeding.

5. Install the lock body on the door and door frame. Drill pilot

holes, if needed, for the fasteners. Use the provided fasteners

to secure the larger part of the lock body to the door and the

smaller part to the frame or wall. If your rim lock set does not

include fasteners, you can use modern nails or screws, or ﬁnd

antique fasteners to compliment your lock.

RIM LOCK SET

Tape Measure

Drill

Wood Chisel

Safety Glasses

Screwdriver

Summary of content (2 pages)

PAGE 1
RIM LOCK SET BEFORE INSTALLING IMPORTANT INFORMATION Read the following installation and care instructions.Observe all local plumbing, building, and electrical codes. Install your tub on an adequately supported and level ﬁnished ﬂoor. These locks are not designed for security. They should not be used on exterior doors unless they are supplemented by an auxiliary deadbolt or other device. INSTALLATION INSTRUCTIONS Unpack and inspect the product for any shipping damages.
PAGE 2
INSTALLATION 6. Attach the door knobs. Separate the door knobs and spindle, if they are assembled in the package. Insert the spindle through the hole on the lock body. If your lock set includes an escutcheon, fasten it to the door with wood screws. Connect the knobs to the spindle on each side of the door. Some old knob sets click together using an integral connector in the spindle. Other knob sets have a hole in the base of the knob where a set screw can be installed.