Installation Sheet

Curved Shower Curtain Rod Installation Instructions 2
CURVED SHOWER CURTAIN ROD
INSTALLATION
5. Drill pilot holes for the wall anchors.
Note: If there is a stud in your mounting location, use wood screws
to attach the wall brackets.
6. Gently tap the anchors into the pilot holes with a
hammer.
8. Attach the rod and brackets to the wall with the mount-
ing hardware provided.
7. Insert the ends of the rod into the wall brackets. Tighten
the set screws with a Philips head screwdriver to secure.
4. Mark the placement of the mounting holes. Use a tape
measure and level to make sure that your pencil marks are
lined up properly on each wall.
For 60" Standard Tub
For 60" Oval Tub
Mount rod approximately 3" inside the point
a straight rod is normally mounted. The
midpoint of the rod should extend several
inches past the outside rim of the tub.
Depending upon tub model, mount rod
between 6" and 8" from center line of the
tub. The middle portion of the rod should
curve just outside the contour of the tub.
2”-3”
6”-8”
X X
Ensure that the markings
are lined up properly.
Mark mounting holes.
X
Pilot Hole
Anchor
Tap anchors into
pilot holes.
Pilot Hole