Installation Sheet

1Straight Shower Curtain Rod Installation Instructions

INSTRUCTIONS

Unpack and inspect the product for any

shipping damages. If you ﬁnd damages, do not

install. Contact Customer Service at

1.866.855.2284. If you need assistance or have

questions while installing your shower rod

contact Customer Service.

We recommend consulting a professional if

you are unfamiliar with installing bathroom

ﬁxtures. Signature Hardware accepts no liability

for any damage to the walls or ceiling, or for

personal injury during installation.

TOOLS AND MATERIALS:

Read entire shower rod installation Instructions.

Observe all local building and safety codes. For

the following installation instructions it is

assumed that any old ﬁxtures have been

removed and any repairs to the wall have

been completed.

BEFORE INSTALLING INSTALLATION

1. Lay the rod sections on the ﬂoor. For rods 84" and longer,

assemble with the connector piece.

2. Verify that the rod sections are the proper length for your

installation. If not, trim with a hacksaw.

3. Hold the wall brackets up at the desired mounting height.

4. Mark the placement of the mounting holes. Use a tape

measure and level to make sure that your pencil marks are

lined up properly on each wall.

STRAIGHT DOUBLE SHOWER CURTAIN ROD

Pencil

Tape Measure

Level

Screwdriver

Drill

Hammer

Hacksaw

¼" Drill Bit

Measure and trim.

X X

Ensure that the markings

are lined up properly.

Mark mounting holes.

PAGE 1
STRAIGHT DOUBLE SHOWER CURTAIN ROD BEFORE INSTALLING INSTALLATION Read entire shower rod installation Instructions. Observe all local building and safety codes. For the following installation instructions it is assumed that any old ﬁxtures have been removed and any repairs to the wall have been completed. 1. Lay the rod sections on the ﬂoor. For rods 84" and longer, assemble with the connector piece. INSTRUCTIONS 2. Verify that the rod sections are the proper length for your installation.
PAGE 2
STRAIGHT DOUBLE SHOWER CURTAIN ROD INSTALLATION 8. Attach the rod and brackets to the wall with the mounting hardware provided. 5. Drill pilot holes for the wall anchors. Note: If there is a stud in your mounting location, use wood screws to attach the wall brackets. Pilot Hole X 6. Gently tap the anchors into the pilot holes with a hammer. Anchor Pilot Hole Tap anchors into pilot holes. 7. Place the wall brackets onto the ends of the shower rod and tighten the set screws secure.