Installation Sheet

1
Pedestal Sink Installation Instructions
Read entire Pedestal Sink Installation Instructions.
Observe all local building and safety codes.
TOOLS AND MATERIALS:
Pencil
BEFORE INSTALLING INSTALLATION
PEDESTAL SINK
1. If the pedestal sink is in two pieces, assemble the basin on top of
the pedestal to confirm proper height and alignment. Place the sink
in position and mark the wall through each of the mounting holes at
the back of the basin.
Tip: Verify that the sink and mounting location are level before marking the
locations of the mounting holes. If the sink is not level, place a shim under the
pedestal or basin and adjust as necessary.
2. Set pedestal aside and drill mounting holes in the locations
designated in the step 1.
3 Attach your new faucet and drain assembly according to the
installation instructions before installing pedestal.
4. Position the pedestal below the installed sink. To hold in place,
apply a bead of silicone sealant along the top and bottom edges of
the pedestal.
5. Attach the water supply and drain lines.
6. When installation is complete, turn on the water supply to check
for any leaking from the water supply lines or pedestal sink basin. If
a lavatory drain is included, move on to the Drain Installation
section.
Level
Drill
Silicone Sealant
(100% Neutral Cure)
INSTRUCTIONS
For the following installation instructions for your new
pedestal sink it is assumed that any old fixtures have
been removed and that the water supply lines and drain
pipe are in place.
Unpack and inspect the product for any shipping
damages. If you find damages, do not install. Contact
Customer Service at 1-866-855-2284. If you need
assistance or have questions while installing your sink,
contact Customer Service.
Because wall construction and materials vary from
home to home, Signature Hardware does not provide
mounting hardware for all of our wall-mount products.
The appropriate mounting hardware can be purchased
from your local hardware store.
If the sink will be mounted to a hollow wall, such as
drywall or plaster, the sink and/or bracket should be
mounted to a solid wood blocking behind the wall via
lag bolts or dowel bolts. If wall studs are unavailable,
such blocking must be installed.
We recommend consulting a professional if you are
unfamiliar with installing bathroom fixtures. Signature
Hardware accepts no liability for any damage to the
floor, walls, plumbing or for personal injury during
installation
Socket Wrench
Crescent Wrench
Basin Wrench
Screwdriver
Thread Sealant