Installation Sheet

2
Pedestal Sink Installation Instructions
1. Disassemble the drain by removing the threaded
tail piece, rubber sealing gaskets, friction washer
and lock nut from the drain body.
2. Place thread sealant on the threaded section of
the tail piece and reattach to the drain body.
3. Slide the flat rubber sealing gasket up the tail
piece to the top of the drain body. This gasket will
create a water tight seal between the drain flange
and sink.
4. Place the drain in the drain hole in the sink.
5. On the underside of the counter, attach the
tapered rubber gasket. With the flat side facing
down, slide the gasket up the threaded shank until
it makes contact with the bottom of the sink.
6. Slide the friction washer up to meet the rubber
gasket.
7. Thread the lock nut onto the threaded shank.
Hand-tighten and make sure that the drain is
properly aligned. When ready, finish tightening
with a basin wrench to secure the drain
DRAIN INSTALLATION
DRAIN INSTALLATION
Flat Rubber Sealing Gasket
Drain Body
Tapered Rubber Sealing
Friction Washer
Lock Nut
Tail Piece
Flat Rubber Sealing Gasket
Drain Body