Installation Sheet

1Glass Corner Shelf Installation Instructions

INSTRUCTIONS

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install.

Contact Customer Service at 1-866-855-2284. If

you need assistance or have questions while

installing your shelf, contact Customer Service.

We recommend consulting a professional if you are

unfamiliar with installing bathroom ﬁxtures.

Signature Hardware accepts no liability for any

damage to the ﬂoor, walls or for personal injury

during installation.

Read entire Glass Corner Shelf Installation

Instructions. Observe all local building and

safety codes.

TOOLS AND MATERIALS:

Pencil

BEFORE INSTALLING SINGLE SHELF INSTALLATION

1. If not assembled, assemble by attaching the front rails

to glass shelves using the supplied screws and washers

(Figure 1).

2. Hold the shelf up to the corner to determine where you

would like to place it. Using a level and pencil, draw a light

line on both walls along both straight edges of the shelf.

3. In the desired mounting location, use the supplied

mounting hardware to mount the bracket on the wall so

that the brackets are from 2/3 to 3/4 of the distance from

the corner to the edge of the shelf. (In the example in

Figure 2, that distance is 5" from the corner.) Bracket

mounting locations may vary, so if your shelf includes

speciﬁcations for mounting the brackets then follow those

speciﬁcations. Repeat on the opposite side.

4. Insert the glass shelf into the mounting brackets. Tighten

the set screws on the underside of the brackets to secure.

Tape Measure

GLASS CONER SHELF

Level

Screwdriver

Drill

PAGE 1
GLASS CONER SHELF BEFORE INSTALLING SINGLE SHELF INSTALLATION Read entire Glass Corner Shelf Installation Instructions. Observe all local building and safety codes. 1. If not assembled, assemble by attaching the front rails to glass shelves using the supplied screws and washers (Figure 1). INSTRUCTIONS Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install. Contact Customer Service at 1-866-855-2284.
PAGE 2
TWO-TIERED SHELF INSTALLATION 1. If not assembled, assemble by attaching the front rails to the glass shelves using the supplied screws and washers (Figure 1). 2. Hold one of the glass shelves up to the corner to determine where you would like to place the top shelf. Using a level and pencil, draw lines on the walls along the straight edges of the top shelf. 3. On the support rail, measure the distance between the notches that will hold the top and bottom glass shelves.
PAGE 3
THREE-TIERED SHELF INSTALLATION 1. If not assembled, assemble by attaching the front rails to the glass shelves using the supplied screws and washers (Figure 1). 2. Hold one of the glass shelves up to the corner to determine where you would like to place the top shelf. Using a level and pencil, draw lines on the walls along the straight edges of the top shelf. 3. On the support rail, measure the distance between the notches that will hold the top and middle glass shelves.