Installation Sheet

ManualsBrandsSignature Hardware ManualsShower FaucetsSignature Hardware Andromeda Thermostatic Stainless Steel Shower Panel with Hand Shower, Two Bodysprays, and LED Lighting

ANDROMEDA THERMOSTATIC SHOWER PANEL

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

plumbing, ﬂoor, walls, tub, or for personal injury during

installation.

Observe all local plumbing and building codes.

Unpack and inspect the item for shipping damage. If any

damage is found, contact our Customer Relations team

at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

Before you begin, the main water supply to your home

should be shut oﬀ.

TOOLS AND MATERIALS:

Plumbers

Tape

Adjustable

Wrench

1Andromeda Thermostatic Shower Panel Installation Instructions

Tape Measure

Level

Drill

Pencil or

Marker

SKU(s): 296157

Summary of content (4 pages)

PAGE 1
SKU(s): 296157 ANDROMEDA THERMOSTATIC SHOWER PANEL BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the plumbing, ﬂoor, walls, tub, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Tape Measure Adjustable Wrench Drill Level Observe all local plumbing and building codes. Unpack and inspect the item for shipping damage.
PAGE 2
ANDROMEDA THERMOSTATIC SHOWER PANEL Installation 1. Before installation, complete the in-wall plumbing. The hot and cold water lines should be prepared 5” on-center. Male ﬁttings will be needed to make the connection to the shower panel’s water lines. 3. Once properly positioned, mark the locations of the upper and lower mounting brackets on the wall. Make a small mark on each side of the panel for each bracket, then set the shower panel aside.
PAGE 3
ANDROMEDA THERMOSTATIC SHOWER PANEL 5. Drill pilot holes into the wall at the marked mounting hole locations. Insert one of the provided anchors into each of the four holes. Important: If drilling through tile, you must use a masonry drill bit. Drill very carefully to avoid cracking the tile. 6. Attach the mounting brackets to the wall as shown, using the provided screws. 7. Attach the hand shower cradle to the shower panel.
PAGE 4
ANDROMEDA THERMOSTATIC SHOWER PANEL 9. Connect the shower panel’s water lines to their installed male ﬁttings on the wall. Ensure that you are connecting the hot and cold lines appropriately. Apply plumber’s tape to the threads before attaching. Tighten using an adjustable wrench. HOT 11. Attach the hand shower to the shower panel using the provided metal hose, as shown. Hand tighten each connection ﬁrmly. COLD 10. Hang the shower panel onto the wall.