Installation Sheet

Ceeley Tempered Glass Shelf Installation Instructions

Drill

CEELEY TEMPERED GLASS SHELF

INSTRUCTIONS

TOOLS AND MATERIALS:

Unpack and inspect the product for any

shipping damages and ensure that none of the

required pieces are missing. If you ﬁnd

damages, do not install. Contact Customer

Service at 1.866.855.2284. If you need

assistance or have questions while installing

your glass shelf, contact Customer Service.

We recommend consulting a professional if you

are unfamiliar with installing bathroom ﬁxtures.

Signature Hardware accepts no liability for any

damage to the shelf or wall, or for personal

injury during installation.

Pencil

Level

Screwdriver

Read the installation instructions below. Observe

all local building and safety codes.

BEFORE INSTALLING INSTALLATION

1. Hold one of your glass shelves up to the wall to determine

where you would like to place the top shelf. Using a level and

pencil, draw a light line on the wall the length of the top shelf.

2. On the support rail, measure the distance between the two

notches that will hold the top and bottom glass shelves. Lightly

draw a horizontal line on the wall at that distance below the ﬁrst

line to indicate the position of the bottom shelf.

3. Attach the rail to the glass shelf using supplied screws and

washers. (Figure 1)

4. Insert the support rails into top and bottom escutcheons.

(Figure 2)

Tape Measure

Safety Glasses

PAGE 1
CEELEY TEMPERED GLASS SHELF BEFORE INSTALLING INSTALLATION Read the installation instructions below. Observe all local building and safety codes. 1. Hold one of your glass shelves up to the wall to determine where you would like to place the top shelf. Using a level and pencil, draw a light line on the wall the length of the top shelf. INSTRUCTIONS 2. On the support rail, measure the distance between the two notches that will hold the top and bottom glass shelves.
PAGE 2
CEELEY TEMPERED GLASS SHELF 5. To mark the escutcheon placement, measure the distance from the closed end of the support rail notch to the center of the neighboring escutcheon. Mark the wall accordingly for each escutcheon. 9. Insert the glass shelves and tighten the set screws to secure. (Figure 4) 6. Hold the mounting brackets up to the wall directly on top of the escutcheon guidelines created in the previous step. Use the screw holes in the mounting brackets to mark your drilling location. 7.