Installation Sheet

2Glass Shelf Installation Instructions

TWO-TIERED GLASS

SHELF INSTALLATION

1. Hold one of your glass shelves up to the wall to

determine where you would like to place the top shelf.

Using a level and pencil, draw a light line on the wall

the length of the top shelf.

2. On the support rail, measure the distance between

the two notches that will hold the top and bottom

glass shelves. Lightly draw a horizontal line on the wall

at that distance below the ﬁrst line to indicate the

position of the bottom shelf.

3. Attach the rails to the glass shelves using supplied

screws and washers. (Figure 1)

4. Insert the support rails into top and bottom

escutcheons. (Figure 2)

5. To mark the escutcheon placement, measure the

distance from the closed end of the support rail notch

to the center of the neighboring escutcheon. Mark

the wall accordingly for each escutcheon.

6. Hold the mounting brackets up to the wall directly

on top of the escutcheon guidelines created in the

previous step. Use the screw holes in the mounting

brackets to mark your drilling location.

7. Use a drill bit that corresponds to the size of the

included screws to drill your mounting holes.

8. Use the supplied screws to aﬃx the mounting

brackets to the walls. Place the assembled support

rail and escutcheon onto the installed mounting

brackets and secure the set screws with supplied

Allen wrench. (Figure 3)

9. Insert the glass shelves and tighten the set screws

to secure. (Figure 4)