Installation Sheet

3
7. Place bolt caps over the anchor bolts on the base of
the toilet.
Tip: If the anchor bolts extend too far over the top
of the washers and nuts, use a hacksaw to trim to
the correct length.
8. If you are installing a two piece toilet, slide the tank
bolts through the mounting holes on the top of the
base of the toilet. If your toilet has only one piece,
move on to step 9.
5. Thread the washers and nuts onto the anchor bolts.
Tip: Before tightening washers and nuts, verify that
your toilet is level. If the toilet is not level place a
shim under the base of the toilet and adjust as
necessary.
6. When toilet is properly aligned, finish tightening the
washers and nuts onto the anchor bolts with your
adjustable wrench. Do this gradually, alternating from
one bolt to the other until both are tight. Be sure not
to overtighten as this could cause cracks and damage
the base of your toilet.
TOILET
INSTALLATION INSTRUCTIONS