Installation Sheet

5Acrylic Clawfoot Tub Installation Instructions
ACRYLIC CLAWFOOT TUB
5. Apply 100% neutral cure silicone sealant to the
underside of the drain flange and thread it through the
tub and into the drain pipe. Apply thread sealant or
plumber’s tape to the threaded connection to ensure
a water-tight seal. Tighten by hand. Wipe away any
excess sealant using a damp cloth.
6. Fill the tub with water to check for any leaks from the
connections. Verify that the drain is working properly.
1. Set the tub in the desired installation location and
drop a plumb line from the center of the overflow hole
to the floor. This will determine your drain location.
Mark the drain hole location on the floor.
2. Move the tub away from the installation location so
that the floor plumbing can be installed. Place the drain
pipe at the appropriate height for the waste and
overflow piping. To determine this, you will need to
temporarily fit your drain pipe into the tub and measure
from the floor to the center of the drain pipe.
TUB AND DRAIN WITH OVERFLOW