Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom FaucetsSignature Hardware Trevana 1.2 GPM Single Hole Vessel Bathroom Faucet with Pop-Up Drain Assembly

1Trevena Single Hole Faucet Installation Instructions

TREVENA SINGLE HOLE FAUCET INSTALLATION

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

faucet, plumbing,sink, counter top, or for personal injury

during installation.

Observe all local plumbing and building codes.

Unpack and inspect the faucet for damage. If any

damage is found, contact our Customer Relations team

at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For these instructions, it is assumed that the old

faucet has been completely removed and any

necessary repairs or modiﬁcations to the water

supply have been completed.

TOOLS AND MATERIALS:

Plumbers Tape

Thread Sealant

Adjustable

Wrench

Small Bucket

Basin Wrench

SKU(s): 917526

Summary of content (5 pages)

PAGE 1
SKU(s): 917526 TREVENA SINGLE HOLE FAUCET INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing,sink, counter top, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Thread Sealant Adjustable Wrench Observe all local plumbing and building codes. Unpack and inspect the faucet for damage.
PAGE 2
TREVENA SINGLE HOLE FAUCET INSTALLATION INSTALLATION 1. Ensure that the water supply below your sink is completely shut oﬀ by turning the shutoﬀ valves all the way to the right. 3. Remove the brass lock nut from the mounting post and set aside. Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. OFF 2. Attach the threaded mounting post to the faucet. Slide the post into the base, and thread into the faucet until hand-tight.
PAGE 3
TREVENA SINGLE HOLE FAUCET INSTALLATION 5. From below, slide the rubber washer onto the mounting post followed by the metal washer. Thread the brass lock nut back into the mounting post to secure. Tighten ﬁrmly. 7. Once installation is complete, turn the main water supply back on from underneath your sink. Check for any leaks underneath. ON 6. Apply plumber’s tape or thread sealant to the threading on each braided water line. Attach the water lines to your main water supply.
PAGE 4
TREVENA SINGLE HOLE FAUCET INSTALLATION DRAIN INSTALLATION 1. Dissasemble the drain assembly and lay the parts aside, in the same order they were removed. See the illustration below as a reference if needed. 2. Apply plumber’s tape to the threading on the tailpiece, then reattach the tail piece to the pop-up drain ﬂange. Pop-Up Drain Flange Flat Rubber Gasket Tapered Rubber Gasket Plastic Friction Washer Lock Nut 3.
PAGE 5
TREVENA SINGLE HOLE FAUCET INSTALLATION 4. Insert the drain ﬂange and tailpiece through the top of your sink’s drain hole. 6. Thread the lock nut onto the drain ﬂange. Hand tighten until secure, then ﬁnish tightening with a basin wrench once the drain is properly aligned. Important: Be careful not to overtighten, which could crack a porcelain sink or stone countertop. COUNTERTOP COUNTERTOP COUNTERTOP COUNTERTOP 5.