Installation Sheet

5. From below, slide the rubber washer onto the
mounting post followed by the metal washer. Thread
the brass lock nut back into the mounting post to
secure. Tighten firmly.
6. Apply plumber’s tape or thread sealant to the
threading on each braided water line. Attach the water
lines to your main water supply. Ensure that you are
connecting the hot and cold lines appropriately.
3
7. Once installation is complete, turn the main water
supply back on from underneath your sink. Check for
any leaks underneath.
TREVENA SINGLE HOLE FAUCET INSTALLATION
8. Proceed to the drain installation. Once complete,
remove the aerator from the spout and turn the
faucet on for testing. Check to ensure that both hot
and cold water are running properly. Allow the water to
flow for approximately 60 seconds to remove any dust
or sediment within the water lines. Turn off and
reattach the aerator.
Trevena Single Hole Faucet Installation Instructions
ON