Manualshelf

Installation Sheet

ManualsBrandsSignature Hardware ManualsShower FaucetsSignature Hardware Traditional Three Way In-Wall Shower Diverter with Lever Handle
1
ROUGH-IN INFORMATION
Drawing is based on a 2 x 4 stud wall, covered by 1/2" cement board, 1/8" of thin set tile mortar, and a finished tile of 1/4" thickness.
Please Note: If the wall dimensions are different than the dimensions shown in this diagram, an adjustment to the installation will be required.
Complete installation, verifying finished wall depth, BEFORE cutting the stem and all-thread tub to length.
All-Thread
3-1/2"
Uncut Length
Stem
Length of Trim
1/8" Thin Set Tile Cement
1/4" Wall Tile
1/2" Rock Board
3-1/2" Wall Stud
1-3/4" Max Cut Length
1-3/4" Hole

Summary of content (1 pages)