Installation Sheet

1Semi-Recessed Sink Installation Instructions

Read entire Semi-Recessed Sink Installation

Instructions. Observe all local building and

safety codes.

TOOLS AND MATERIALS:

BEFORE INSTALLING INSTALLATION

1. Carefully turn the sink over to rest upside down on the vanity top.

2. Apply a continuous bead of silicone to the outer edge of the

sink where it will contact the vanity top.

3. Turn the sink back over, placing it inside the sink cutout and

position until centered.

4. Remove any excess silicone with a cloth moistened with water or

mineral spirits. Let silicone dry for 24 hours. If a lavatory drain is

included, move on to the Drain Installation section.

Silicone

Sealant

INSTRUCTIONS

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install. Contact

Customer Service at 1-866-855-2284. If you need

assistance or have questions while installing your sink,

contact Customer Service.

For this installation it is assumed that the vanity top has

been cut to the dimensions of the sink. We recom-

mend consulting a professional if you are unfamiliar

with this type of installation, Signature Hardware

accepts no liability for any damages to the ﬂoor, walls,

plumbing or for personal injury during installation.

Damp Cloth

SEMI-RECESSED SINK

Thread

Sealant

Basin Wrench

24 hr

PAGE 1
SEMI-RECESSED SINK BEFORE INSTALLING INSTALLATION Read entire Semi-Recessed Sink Installation Instructions. Observe all local building and safety codes. 1. Carefully turn the sink over to rest upside down on the vanity top. INSTRUCTIONS Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install. Contact Customer Service at 1-866-855-2284. If you need assistance or have questions while installing your sink, contact Customer Service.
PAGE 2
DRAIN INSTALLATION DRAIN INSTALLATION 1. Disassemble the drain by removing the threaded tail piece, rubber sealing gaskets, friction washer, and lock nut from the drain body. 3. Place the drain in the drain hole in the sink. On the underside of the counter, attach the tapered rubber gasket. With the ﬂat side facing down, slide the gasket up the threaded shank until it makes contact with the bottom of the sink.