Installation Sheet

2Semi-Recessed Sink Installation Instructions

1. Disassemble the drain by removing the threaded

tail piece, rubber sealing gaskets, friction washer,

and lock nut from the drain body.

2. Place thread sealant on the threaded section of

the tail piece and reattach to the drain body. Slide

the ﬂat rubber sealing gasket up the tail piece to the

top of the drain body. This gasket will create a water

tight seal between the drain ﬂange and sink.

3. Place the drain in the drain hole in the sink. On the

underside of the counter, attach the tapered rubber

gasket. With the ﬂat side facing down, slide the

gasket up the threaded shank until it makes contact

with the bottom of the sink.

4. Slide the friction washer up to meet the rubber

gasket. Thread the lock nut onto the threaded

shank. Hand-tighten and make sure that the drain is

properly aligned. When ready, ﬁnish tightening with

a basin wrench to secure the drain.

Flat Rubber Sealing Gasket

Drain Body

Tapered Rubber Sealing

Friction Washer

Lock Nut

Tail Piece

DRAIN INSTALLATION