Installation Sheet

1Grab Bar Installation Instructions
GRAB BAR
INSTRUCTIONS
TOOLS AND MATERIALS:
Masking Tape
Unpack and inspect the product for any
shipping damages. If you find damages, do not
install. Contact Customer Service
at 1-866-855-2284. If you need assistance or
have questions while installing your grab bar,
contact Customer Service.
In order to support the maximum weight limit,
grab bars must be anchored to solid wood
blocking installed between wall studs. We
recommend consulting a professional if you are
unfamiliar with this type of installation.
We recommend consulting a professional if you
are unfamiliar with installing bathroom fixtures.
Signature Hardware accepts no liability for any
damage to the floor, walls or for personal injury
during installation.
Stud Finder
Pencil
Level
Drill Screwdriver
Read entire grab bar installation instructions.
Observe all local building and safety codes.
BEFORE INSTALLING INSTALLATION
Mounting Screws
Mounting Screws
Wall Flange Front View
Wall Flange
Decorative
Escutcheon
1. Slide or unthread the decorative escutcheon to expose
the wall flange.
2. Determine the installation location and mark the location
of the mounting holes using the template (if included) or wall
flange. This location will vary, we recommend installing your
grab bar approximately waist high for the user. Use a level to
verify that your grab bar is properly aligned.
3. Drill mounting holes using the appropriate drill bit for the
wall surface or material.
4. Remove masking tape from the installation location if
applicable.
5. Attach the grab bar to the wall with the mounting screws
provided.
6. Slide or thread the decorative escutcheons over the wall
flanges and press firmly in place to complete installation.
Tip: Place masking tape in the installation location when marking the mounting
holes to see the outline clearly and keep your drill from damaging the mounting
surface.