Air Kit Installation

1. Remove your tub from its packaging. Carefully turn
the tub upside down or on its side, and lay it on a sheet
of cardboard, or a soft surface, to prevent scratching.
The air system’s jets, tubing, and manifold should be
pre-installed into your tub. Check all pre-installed
connections to ensure that nothing came loose or
dislodged during shipping.
2. Secure the blower motor in its designated
location using the provided hardware. It is assumed
that the electrcal requirements have been met, and
that the receptable has been prepared.
Note: Due to variations in mounting surfaces and
locations, the provided hardware may or may not be
sufficient. You may need to provide your own hardware
depending on the circumstance.
3. Plug the remote-control receiver module into the
designated location on the side of the blower motor.
Mount the remote-control receiver module to a
surrounding wall or surface, as close to the tub as
possible and in plain view.
Important: If the receiver module is not in plain view
from the tub’s location, your remote control will not
function properly.
3
4. Connect one end of the 3’ air hose to the blower
motor outlet. Use a provided hose clamp to secure.
Connect the opposite end of the hose to the security
device, using another hose clamp to secure.
Note: You will need to use a provided 1-1/4” hose
adapter to connect the hose to the security device.
Air Massage Kit Installation Instructions
AIR MASSAGE KIT INSTALLATION INSTRUCTIONS
cardboard or
soft surface