Manualshelf

Air Kit Installation

ManualsBrandsSignature Hardware ManualsShop All Signature HardwareSignature Hardware Neva 64" Resin Freestanding Air Tub
1234567
7
Air Massage Kit Installation Instructions
AIR MASSAGE KIT INSTALLATION INSTRUCTIONS
If the blower is not operating properly:
- Verify that the blower motor is plugged into the wall.
- Check your electric power supply. Reset the circuit breaker or replace the fuse if necessary.
- If the system has been functioning for quite some time, it is possible that the thermic protection has shut off the motor.
Let it cool off for at least 30 minutes before using it again.
If the motor is running, but no air is coming through the jets:
- Verify that the main air hose is properly connected from the manifold to the air pump.
- Check the main air hose for any rips, cracks, or holes where air could escape.
If only some jets are functioning:
- Fill your tub with warm water, and switch the system ON and OFF several times to loosen any debris that could be
clogging the jets.
- Cover the non-working jet with a soft cloth and carefully tap on the jet head with the handle of a screw driver, or a
rubber mallet, while the blower is running. This will dislodge the inner ball bearing which may be stuck. Tip: After using
the tub, drain the water and let the system run for a few minutes to dry the jets. This will prevent the ball bearings from
becoming lodged in the future.
- If tapping on the jets does not work, remove the plastic jet cap from the non-working jet. Slide a small tool, such as a
flat head screwdriver, between the jet wall and the ball bearing to break the bearing loose from any remaining residue.
If the air heater is not working properly:
- To verify the operation of the air heater, fill the bathtub to working level and operate the blower for approximately 5
minutes. Carefully feel the main hose where it is connected to the blower. The hose and its immediate area should feel
warm to the touch. If the hose and the surrounding air do not feel warm, contact customer service.
If your tub is installed against to outside walls, make sure that the walls are adequately insulated to minimize heat loss.
TROUBLESHOOTING