Installation Sheet

6
Victorian Widespread Faucet Installation Instructions
LIFT ROD SINK DRAIN INSTALLATION
INSTALLATION
1. Remove the flange by unthreading it from the drain
body. Remove the flat rubber gasket as well.
2. Set the flat rubber gasket over the drain hole in your
sink, then insert the flange into the drain hole.
3. From beneath the sink, reattach the flange by
threading it back onto the drain body.
4. Connect the drain lever by threading it into the hole
on the side of the drain body. The lever must pass
through the hole in the stopper tailpiece to function
properly. Apply a bit of thread sealant or plumber’s tape
to the threads before attaching.