Installation Sheet

1Freestanding Tub Faucet Installation Instructions
FREESTANDING TUB FAUCET
INSTALLATION INSTRUCTIONS
Before you begin, read the installation instructions below. Observe all local plumbing and building codes.
For the following installation instructions for your new Freestanding Tub Faucet it is assumed that the water supply lines
are in place underneath the oor and are directly accessible for faucet installation.
A round hole, 1-½" in diameter, will provide access to the water supply lines when mounting your faucet. The distance
from the water supply lines to the mounting location should be approximately 4-6".
Installation on a concrete slab is not recommended.
Because construction and materials vary from home to home, Signature Hardware does not provide mounting
hardware for all of our freestanding tub faucets. The appropriate mounting hardware can be purchased from your local
hardware store.
Unpack and inspect faucet for any shipping damages and ensure that none of the required pieces are missing. If you nd
any damages, do not install. Contact Customer Service at 1-866-855-2284. If you need assistance while installing your
new Freestanding Tub Faucet, call our Customer Service number.
We recommend consulting a professional if you are unfamiliar with installing bathroom xtures and plumbing. Signature
Hardware accepts no liability for any damages to the oor, walls, plumbing or personal injury during installation.
Shut off the water supply lines at the tub where the new faucet is being installed.
TOOLS AND MATERIALS:
INSTALLATION
1. Lay the faucet down at so that all parts can be easily viewed and accessed during assembly.
2. Slide the decorative escutcheon, or base, onto the body of the faucet if it is not already attached. You may need to
remove the mounting plate and/or hex nut (if included) if they are already in place. If there is no decorative
escutcheon and the mounting plate is not removable, move on to step 4.
Tip: Make sure the rubber sealing gasket (if included) is around the rim of the escutcheon. Shift the escutcheon up
the faucet so that you have enough room for your tools during installation.
3. Attach the mounting plate to the body of the faucet. If a hex nut was included with your faucet, screw the nut onto the
body of the faucet followed by the mounting plate. The two should t tightly together to create a seal.
Level Masking Tape Drill
Shim Allen Wrench (provided) Adjustable Wrench