Installation Sheet

1Single Hole Faucet Installation Instructions

SINGLE HOLE FAUCET

INSTALLATION INSTRUCTIONS

Before installing, read entire Single Hole Faucet Installation Instructions. Observe all local building and safety codes.

For the following installation instructions for your new Single Hole Faucet it is assumed that any old xtures have been

removed and any repairs or modications to the water supply have been completed.

Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer Service

at 1-866-855-2284. If you need assistance or have questions while installing your Single Hole Faucet, contact Customer

Service.

We recommend consulting a professional if you are unfamiliar with installing kitchen xtures. Signature Hardware

accepts no liability for any damage to the oor, walls, plumbing or for personal injury during installation.

Turn off the water supply at the sink where the new faucet is being installed.

TOOLS AND MATERIALS:

INSTALLATION

1. Remove the lock nut from the faucet body.

2. If not already connected, attach the exible water feed tubes to the tail-piece. Hot water is always on the left and cold

water is always on the right.

3. Place the metal mounting washer, or clip, and rubber sealing gasket over the mounting hole.

4. If a decorative mounting plate, or escutcheon, is included place over the mounting hole. If there is no decorative plate

move on to the next step.

5. Thread the faucet through the mounting hole and mounting hardware and thread the washer (if included) and lock

nut onto the tail-piece from underneath the sink. Make sure that faucet is properly aligned and tighten the nut with your

adjustable wrench.

Note: If there is a separate mounting rod, remove the mounting nut and screw the rod into the faucet body. Thread the

rod through the mounting hole and tighten the mounting nut to secure.

6. If your faucet features a side spray, install by inserting the sprayer housing, and rubber sealing gasket through the

mounting hole. Secure by tightening the lock nut from underneath the sink. If your faucet does not have a side spray

move on to step 9.

7. Insert the side spray hose through the sprayer housing and attach to the spray hose outlet on the faucet.

Tip: Before you connect the spray hose to the faucet, make sure that it is in a position that will allow you to pull it out

easily without getting caught on any other xtures under the sink.

Adjustable Wrench Basin Wrench

PAGE 1
SINGLE HOLE FAUCET INSTALLATION INSTRUCTIONS Before installing, read entire Single Hole Faucet Installation Instructions. Observe all local building and safety codes. For the following installation instructions for your new Single Hole Faucet it is assumed that any old fixtures have been removed and any repairs or modifications to the water supply have been completed. Unpack and inspect the product for any shipping damages. If you find damages, do not install. Contact Customer Service at 1-866-855-2284.
PAGE 2
8. Hand tighten to attach the water feed tubes to the main water supply, being careful not to cross the two during installation. Give a ¼ turn with pliers or wrench, but don’t over tighten. Curve tubes as necessary to ensure there are no kinks or knots. 9. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight (no water should be leaking) and that the hot and cold supplies are working correctly.