Installation Sheet

STEYN KITCHEN FAUCET INSTALLATION

Installation

3. From beneath the sink, slide the brass spacer back

onto the faucet body. Thread the locknut back onto the

threaded shank until hand-tight to secure. Finish

tightening using an adjustable wrench.

4. Attach the sprayer hose to its copper mounting post

as shown. Insert the provided rubber O-ring into the

lock nut before securing. Apply a bit of thread sealant

or plumber’s tape to the threads before tightening.

Important: Hand tighten, then use an adjustable

wrench to give the lock nut no more than a ¼ turn to

complete tightening. Do not overtighten, which can

crack or break the copper mounting post.

1. Ensure that the water supply below your sink is

completely shut oﬀ by turning the shutoﬀ valves all the

way to the right.

Tip: Place a small bucket below your workspace to

catch any water that may drip during the installation

process.

2. Remove the lock nut and brass spacer from the

faucet body. Insert the faucet into its mounting hole.

2Steyn Kitchen Faucet Installation Instructions

OFF