Installation Sheet

2Rear Outlet Toilet Installation Instructions
4. Trim the p-trap adapter with a hacksaw to the appropriate
length as necessary.
5. Mark the location of the pre-drilled mounting holes using
the holes in the base of the toilet as a template.
6. Remove the toilet from the work area and drill mounting
holes in the locations designated in the previous step.
7. Apply PVC or ABS glue around the p-trap connector and
place inside the hub fitting.
8. Slide the toilet into place and press the waste outlet into
the p-trap connector.
9. Once the toilet is securely in place, insert anchor bolts
and washers through the mounting holes in the base of the
toilet and tighten into the pre-drilled holes created in step 6.
INSTALLATION (STEPS 4-9)