DUMMY, PASSAGE, AND PRIVACY SET INSTALLATION INSTRUCTIONS CONTENTS Dummy Set Installation 2 Passage Set Installation 3 Privacy Set Installation 4 Dummy, Passage and Privacy Set Installation Instructions 1
BEFORE INSTALLING DUMMY SET INSTALLATION Before you begin, read the installation instructions below. Observe all local building and safety codes. 1. Place the dummy spindle (A) on the door in the door knob location. 2. Use the dummy spindle as a template to mark and drill pilot holes for the mounting hardware. INSTRUCTIONS For the following installation instructions it is assumed that any holes for the handle and lock set have been pre-drilled. Unpack and inspect the product for any shipping damages.
PASSAGE SET INSTALLATION B A 1. Insert the latch bolt (A) into the edge of the door. The curved edge should touch the frame when the door is closed. Note: If the latch bolt plate is not flush with the door, carefully chisel out, or mortise, a small part of the door. 2. Use the latch bolt plate as a template to mark and drill pilot holes for the mounting hardware. D C 3. Insert the latch bolt (A) and decorative faceplate (B) and secure with two wood screws (C). 4.
PRIVACY SET INSTALLATION B A 1. Insert the latch bolt (A) into the edge of the door. The curved edge should touch the frame when the door is closed. Note: If the latch bolt plate is not flush with the door, carefully chisel out, or mortise, a small part of the door. 2. Use the latch bolt plate as a template to mark and drill pilot holes for the mounting hardware. D C 3. Insert the latch bolt (A) and decorative faceplate (B) and secure with two wood screws (C). 4.