Installation Sheet

ManualsBrandsSignature Hardware ManualsToiletsSignature Hardware Ebler 1.6 / 0.8 GPF Two Piece Elongated Toilet with Rear Outlet - Seat Included

1Rear Outlet Toilet Installation Instructions

INSTRUCTIONS

For the following installation instructions for your

new toilet it is assumed that any old ﬁxtures have

been removed and that the toilet ﬂange is in the

proper location for installation (refer to

speciﬁcation sheet).

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install.

Contact Customer Service at 1-866-855-2284.

If you need assistance or have questions while

installing your toilet, contact Customer Service.

We recommend consulting a professional if you

are unfamiliar with installing bathroom ﬁxtures.

Signature Hardware accepts no liability for any

damage to the ﬂoor, walls, plumbing or for

personal injury during installation.

Shut oﬀ the water supply lines where the new

toilet is being installed.

1. If you are installing a two-piece toilet, slide the tank bolts

through the mounting holes on the top of the base of the

toilet and thread the washers and nuts onto the tank bolts.

Verify that the tank is level and alternately tighten the

washers and nuts until the tank is resting ﬁrmly on the bowl.

If your toilet is one piece only, move on to the next step.

2. Place the toilet in the location where it will be installed.

3. Measure the distance from the back of the waste outlet

on the toilet to the wall hub ﬁtting to determine the length

of the p-trap connector. The connector should extend

approximately 1-1/2" into the hub ﬁtting.

TOOLS AND MATERIALS:

INSTALLATION

Read entire Rear Outlet Toilet Installation

Instructions. Observe all local building and

safety codes.

BEFORE INSTALLING

REAR OUTLET TOILET

Pencil

Drill

Level

Adjustable

Wrench

Hacksaw

PVC Glue

Summary of content (3 pages)

PAGE 1
REAR OUTLET TOILET BEFORE INSTALLING Read entire Rear Outlet Toilet Installation Instructions. Observe all local building and safety codes. INSTRUCTIONS INSTALLATION 1. If you are installing a two-piece toilet, slide the tank bolts through the mounting holes on the top of the base of the toilet and thread the washers and nuts onto the tank bolts. Verify that the tank is level and alternately tighten the washers and nuts until the tank is resting ﬁrmly on the bowl.
PAGE 2
INSTALLATION (STEPS 4-9) 4. Trim the p-trap adapter with a hacksaw to the appropriate length as necessary. 7. Apply PVC or ABS glue around the p-trap connector and place inside the hub ﬁtting. 8. Slide the toilet into place and press the waste outlet into the p-trap connector. 5. Mark the location of the pre-drilled mounting holes using the holes in the base of the toilet as a template. 6. Remove the toilet from the work area and drill mounting holes in the locations designated in the previous step. 9.
PAGE 3
INSTALLATION (STEPS 10-13) 10. Place caps over the anchor bolts on the base of the toilet. 13. Finish your installation by applying latex caulk or tile grout around the base of the toilet. This will ﬁnish the joint between your ﬂoor and toilet bowl and divert water away from the base of the toilet. 11. Connect the water supply tubes at the bottom of the tank. Turn on the water supply and ﬂush the toilet several times to check for any leaks around the back or base. 12. Attach the toilet seat.