Installation Sheet

ManualsBrandsSignature Hardware ManualsToiletsSignature Hardware Luther 1.28 GPF Elongated Two-Piece Toilet - Standard Seat Included

BEFORE YOU BEGIN

Read entire Toilet Installation Instructions. Observe all

local building and safety codes.

For the following installation instructions for your new

toilet it is assumed that any old ﬁxtures have been

removed and any repairs to the water supply and/or

toilet ﬂange have been completed.

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install. Contact

Customer Service at 1-866-855-2284. If you need

assistance or have questions while installing your toilet,

contact Customer Service.

We recommend consulting a professional if you are

unfamiliar with installing bathroom ﬁxtures. Signature

Hardware accepts no liability for any damage to the ﬂoor,

walls, plumbing or for personal injury during installation.

Shut oﬀ the water supply lines where the new toilet is

being installed.

GETTING STARTED

Ensure that you have gathered all the required

materials that are needed for the installation.

TOILET

INSTALLATION INSTRUCTIONS

REVISED 03/13/2019

TOOLS AND MATERIALS:

Level

Latex Caulk

Adjustable Wrench

Hacksaw

Wood Shims

Wax Ring

Summary of content (5 pages)

PAGE 1
TO I L E T INSTALLATION INSTRUCTIONS TOOLS AND MATERIALS: BEFORE YOU BEGIN Read entire Toilet Installation Instructions. Observe all local building and safety codes. For the following installation instructions for your new toilet it is assumed that any old ﬁxtures have been removed and any repairs to the water supply and/or toilet ﬂange have been completed. Level Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install. Contact Customer Service at 1-866-855-2284.
PAGE 2
TO I L E T INSTALLATION INSTRUCTIONS INSTALLATION 1. Press the new wax ring into place on the toilet ﬂange on the ﬂoor with the ﬂat side down and the tapered edge up. Apply enough pressure to hold the ring in place during installation but be careful not to press it out of shape. 3. When the wax ring and bolts are attached, lift the toilet and align the mounting holes with the anchor bolts on the ﬂoor for proper placement. 2. Install the anchor bolts through the toilet ﬂange.
PAGE 3
TO I L E T INSTALLATION INSTRUCTIONS 5. Thread the washers and nuts onto the anchor bolts. 7. Place bolt caps over the anchor bolts on the base of the toilet. Tip: Before tightening washers and nuts, verify that your toilet is level. If the toilet is not level place a shim under the base of the toilet and adjust as necessary. Tip: If the anchor bolts extend too far over the top of the washers and nuts, use a hacksaw to trim to the correct length. 6.
PAGE 4
TO I L E T INSTALLATION INSTRUCTIONS 9. Thread washers and nuts onto the tank bolts. Verify that the tank is level and alternately tighten the washers and nuts until the tank is resting ﬁrmly on the bowl. 11. If you purchased a bidet seat, connect the three-way valve and hose to the inlet of the toilet seat. Then, using a second hose, connect the opposite end of the three-way valve to the toilet’s main shutoﬀ valve on the wall, as shown.
PAGE 5
TO I L E T INSTALLATION INSTRUCTIONS 13. Finish your installation by applying latex caulk or tile grout around the base of the toilet. This will ﬁnish the joint between your ﬂoor and toilet bowl and divert water away from the base of the toilet.