Installation Sheet

1Overﬂow Drain Installation Instructions

Press and Seal Swivel Drain

OVERFLOW DRAIN

INSTRUCTIONS

TOOLS AND MATERIALS:

Unpack and inspect drain for any shipping

damages. If you ﬁnd any damages, do not

install. Contact Customer Service at

1-866-855-2284. If you need assistance

while installing your new Overﬂow Drain,

call our Customer Service number.

We recommend consulting a professional if

you are unfamiliar with installing bathroom

ﬁxtures and plumbing. Signature Hardware

accepts no liability for any damages to the

ﬂoor, walls, plumbing or personal injury

during installation.

BEFORE INSTALLING INSTALLATION

Because tubs vary in size, measure your space thoroughly before

installation. Trim pipes accordingly to ensure a correct ﬁt. Go to the

Trimming Drain Pipes section for more information.

1. Apply thread sealant or plumber’s tape to the threads at each end

of all pipes prior to installation. If two pipes arrive attached, be sure to

take them apart and apply sealant before installing.

2. Connect the tub shoe assembly (A), and rubber washer to the tub

drain (B).

3. Install the overﬂow assembly (C) with the beveled washer, overﬂow

plate, mounting screw (provided) and any other washers or rubber

sealing gaskets included.

4. Attach the waste and overﬂow tee (D) to the overﬂow assembly (C)

and shoe assembly (A) with sealing washers and slip nuts.

5. Attach the drain tube and ﬂange (E) to the waste and overﬂow tee

(D) with the sealing washer and slip nut.

Read entire installation instructions. Observe

all local plumbing and building codes.

Screwdriver

Thread Sealant

Adjustable Wrench

Hacksaw

Pliers

Pipe Wrench

PAGE 1
OVERFLOW DRAIN BEFORE INSTALLING INSTALLATION Read entire installation instructions. Observe all local plumbing and building codes. Because tubs vary in size, measure your space thoroughly before installation. Trim pipes accordingly to ensure a correct ﬁt. Go to the Trimming Drain Pipes section for more information. INSTRUCTIONS 1. Apply thread sealant or plumber’s tape to the threads at each end of all pipes prior to installation.
PAGE 2
TRIMMING DRAIN PIPES 1. Connect the overﬂow and drain assemblies and pipes to the tub. 2. The T-connection will be attached at the points where the drain pipes intersect. Measure and mark each pipe so that the ends reach a little over halfway into the T-Connection hubs. 3. Trim the pipes as necessary with a hack saw with a blade that is suitable for cutting metal.