Installation Sheet

1Outdoor Shower Panel Installation Instructions
OUTDOOR SHOWER PANEL
INSTALLATION INSTRUCTIONS
Before installing, read entire Outdoor Shower Panel Installation Instructions. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1.866.855.2284. If you need assistance or have questions while installing your outdoor shower panel, contact
Customer Service.
Because wall construction and materials vary from home to home, Signature Hardware does not provide mounting
hardware for all of our outdoor products. The appropriate mounting hardware can be purchased from your local hardware
store.
We recommend consulting a professional if you are unfamiliar with installing outdoor and plumbing xtures. Signature
Hardware accepts no liability for any damage to the shower, installation surface, or for personal injury during installation.
TOOLS AND MATERIALS:
Drill Mounting Hardware Level
Adjustable Wrench
INSTALLATION
1. Holding the panel in place, determine your installation
location and mark the position of the mounting holes for
drilling.
2. Drill screw holes with the appropriate drill bit for the wall
surface or material.
3. Attach the mounting bracket to the wall with the
mounting hardware.
4. Attach the hand shower hose to the outlet on the side of
the shower panel. Do this gradually, alternating from one
nut to the other until both are tight.
5. If a separate shower arm is included, insert the new arm
into the tting in the panel and twist to tighten. Finish
tightening with an adjustable wrench. Wrap a dry cloth
around the shower arm to protect the nish while
tightening. Thread the new shower head onto the arm
and hand-tighten.
6. Connect the exible water feed tube(s) to the water
supply.
7. Turn on the water supply to make sure there are
no leaks in the water feed tube(s). If no leaks are
detected, continue with installation. If leakage
does occur, use your adjustable wrench to tighten
the connections as necessary. If problems persist,
contact Customer Service at 1-866-855-2284.
8. Attach the shower panel to the wall by hanging
from the mounting bracket. Check to make sure it
is hung rmly and level, adjust as necessary.
9. When the shower panel is in place, turn on the
water, check to make sure that all connections are
tight (no water should be leaking) and that the
water supplies are working correctly. Divert the
water to the each output and allow the water to
ow for approximately 60 seconds.