Installation Sheet

1Stainless Steel Pull Chain Outdoor Shower Installation Instructions
STAINLESS STEEL PULL CHAIN OUTDOOR SHOWER
INSTALLATION INSTRUCTIONS
Before installing, read entire Outdoor Shower Installation Instructions. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1.866.855.2284. If you need assistance or have questions while installing your Outdoor Shower, contact
Customer Service.
Because wall construction and materials vary from home to home, the appropriate mounting hardware for your surface
may need to be purchased from your local hardware store.
We recommend consulting a professional if you are unfamiliar with installing outdoor and plumbing xtures. Signature
Hardware accepts no liability for any damage to the shower, installation surface, or for personal injury during installation.
TOOLS AND MATERIALS:
Pencil Drill Silicone Sealant Damp Cloth
INSTALLATION
1. Apply plumbers tape (included) to the threaded ends of the 6" pipe
and attach the pipe directly to the water supply line.
2. Slide the decorative escutcheon over the pipe.
3. Thread the pull chain valve onto the 6" pipe. Hand tighten and
adjust as necessary for proper alignment.
4. Slide the support arm onto the shower arm.
5. Wrap plumbers tape around the threaded ends of the shower arm.
Attach the shower arm to the pull chain valve.
6. Hold the support arm in place and mark the location of the
mounting holes in the wall ange on the installation surface.
7. Drill pilot holes in the locations marked in the previous step and
install anchors (included). Drive mounting screws through the ange, into the anchors, to attach the support arm to
the installation surface.
8. Tighten the set screw on the support arm with the provided Allen wrench.
9. Attach the shower head to the shower arm.
10. Turn on the water supply to check for leaks. If no leaks are detected, apply silicone sealant to the back of the
decorative escutcheon and press into place against the installation surface. Wipe away any excess sealant with a
damp cloth. Allow the silicone sealant to dry for 24 hours.