Installation Sheet
1Barlow Wall-Mount Faucet Installation Instructions
BARLOW WALL-MOUNT FAUCET
INSTALLATION INSTRUCTIONS
Before installing, read entire installation instructions. Observe all local building and safety codes.
For the following installation instructions it is assumed that the water supply lines have been installed in the desired
faucet location. A ½" female tting should be attached to the water supply line and in line with the nished wall.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1-866-855-2284. If you need assistance or have questions while installing your faucet, contact Customer
Service.
We recommend consulting a professional if you are unfamiliar with installing bathroom xtures and plumbing. Signature
Hardware accepts no liability for any damages to the oor, walls, plumbing or for personal injury during installation.
TOOLS AND MATERIALS:
INSTALLATION
1. Wrap Teon pipe tape around the threaded portions of the wall couplers.
2. Thread the wall couplers into the female ttings at the nished wall.
3. Thread the escutcheons onto the wall couplers.
4. Place the faucet body on the wall couplers. Hand tighten the coupling nuts to secure.
5. Finish your installation by attaching the hand shower to the faucet body.
6. After all connections have been made, turn on the water supply, check to make sure that all connections are tight
(no water should be leaking) and that the hot and cold supplies are working correctly. Turn the faucet on and allow
the water to ow through the spout for approximately 60 seconds. Divert the water to the hand shower and allow the
water to ow through the hose for an additional 60 seconds.
Teon Pipe Tape