Installation Sheet

1Recessed Medicine Cabinet Installation

RECESSED MEDICINE CABINET

INSTRUCTIONS

TOOLS AND MATERIALS:

Unpack and inspect the product for any

shipping damages. If you ﬁnd damages, do

not install. Contact Customer Service at

1-866-855-2284. If you need assistance or

have questions while installing your cabinet,

contact Customer Service.

A recessed medicine cabinet needs to be

anchored inside the wall to rectangular

framing. This framing must be clear of all

obstructions. If there are any wires or

plumbing lines that cannot be relocated

you will need to install a surface-mount

cabinet.

We recommend consulting a professional if

you are unfamiliar with this type of installation.

Signature Hardware accepts no liability for any

damage to the cabinet or wall, or for personal

injury during installation.

BEFORE INSTALLING INSTALLATION

1. To cut the hole for your recessed cabinet, center the cabinet

above the sink at the appropriate height and draw a leveled

outline of your cabinet on the wall.

2. Score the outline with a utility knife and level. After the area is

scored, cut out the area with a keyhole or reciprocating saw and

remove the drywall.

Read entire Recessed Medicine Cabinet

Installation Instructions. Observe all local

building and safety codes.

Pencil

Level

Drill

Tape Measure

Utility Knife

Wood Shims

Height of

the cabinet

Height inbetween

the cabinet and vanity

Center the cabinet

Score and cut the outline

PAGE 1
RECESSED MEDICINE CABINET BEFORE INSTALLING INSTALLATION Read entire Recessed Medicine Cabinet Installation Instructions. Observe all local building and safety codes. 1. To cut the hole for your recessed cabinet, center the cabinet above the sink at the appropriate height and draw a leveled outline of your cabinet on the wall. INSTRUCTIONS Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install. Contact Customer Service at 1-866-855-2284.
PAGE 2
3. When the space has been cleared of all obstructions, ﬁrmly attach horizontal 2 x 4 blocking to the vertical wall studs with wood screws to create the framing for your cabinet. Make sure the drywall is secured to the edge of the wall studs, inserting screws as necessary. Locate and mark on the wall 4. Remove the medicine cabinet door(s), set aside and slide the medicine cabinet into place. Verify that the cabinet is level; use shims to adjust as necessary. 5.