Installation Sheet

BEFORE YOU BEGIN

Before installing, read entire outdoor shower installation

Instructions. Observe all local building and safety codes.

For the following installation instructions it is assumed

that the water supply has been installed in the desired

location and is accessible for shower installation.

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install. Contact

Customer Service at 1.866.855.2284. If you need

assistance or have questions while installing your

shower panel, contact Customer Service.

We recommend consulting a professional if you are

unfamiliar with installing bathroom ﬁxtures. Signature

Hardware accepts no liability for any damage to the seat

or wall, or for personal injury during installation.

Note: Make sure to winterize your outdoor shower

before cold weather arrives to prevent burst pipes and

protect the shower's hardware.

GETTING STARTED

Ensure that you have gathered all the required

materials that are needed for the installation.

For these instructions, it is assumed that the old

faucet has been completely removed and any

necessary repairs or modiﬁcations to the water

supply have been completed.

SHOWER PANEL

INSTALLATION INSTRUCTIONS

REVISED 02/27/2019

TOOLS AND MATERIALS:

Drill

Level

Mounting

Hardware

Adjustable

Wrench

Silicone Sealant

(100% Neutral

Cure)

Damp Cloth

PAGE 1
S H O W E R PA N E L INSTALLATION INSTRUCTIONS TOOLS AND MATERIALS: BEFORE YOU BEGIN Before installing, read entire outdoor shower installation Instructions. Observe all local building and safety codes. For the following installation instructions it is assumed that the water supply has been installed in the desired location and is accessible for shower installation. Damp Cloth Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install. Contact Customer Service at 1.866.
PAGE 2
S H O W E R PA N E L INSTALLATION INSTRUCTIONS INSTALLATION 7. Turn on the water supply to make sure there are no leaks in the water feed tubes before you ﬁx the shower to the wall. If no leaks are detected, continue with installation. 1. Holding the panel in place, determine your installation location and mark the position of the mounting holes for drilling. 2. Drill the screw holes with the appropriate drill bit for the wall surface or material.