Installation Sheet

ManualsBrandsSignature Hardware ManualsShower FaucetsSignature Hardware Alvin Stainless Steel Thermostatic Outdoor Shower Panel with Shower Head, Hand Shower, Bodysprays and Bamboo Tray

1Alvin Outdoor Shower Installation Instructions

ALVIN OUTDOOR SHOWER INSTALLATION

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

ﬂoor, walls, plumbing, or personal injury during installa-

tion.

Observe all local building and safety codes.

Unpack and inspect the shower for damage. If any

damage is found, contact our Customer Relations team

at 1-866-855-2284.

Pencil

Tape Measure

Thread Sealant

Plumber’s Tape

Adjustable

Wrench

Level

For the following instructions, it is assumed that the

installation area is prepared and the water supply lines

are in place.

Ensure that you have gathered all of the required

materials that are needed for the installation.

Phillips

Screwdriver

SKU(s): 413242

Summary of content (4 pages)

PAGE 1
SKU(s): 413242 ALVIN OUTDOOR SHOWER INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the ﬂoor, walls, plumbing, or personal injury during installation. TOOLS AND MATERIALS: Pencil Tape Measure Plumber’s Tape Thread Sealant Phillips Screwdriver Level Observe all local building and safety codes. Unpack and inspect the shower for damage.
PAGE 2
ALVIN OUTDOOR SHOWER INSTALLATION INSTALLATION 1. Attach the shower panel to the shower base, as shown. Use the provided bolts, nuts, and washers to fasten. Tighten ﬁrmly. 3. Remove the lock nut and rubber washer from the hand shower cradle. Attach the hand shower cradle to the shower unit, as shown. Use an adjustable wrench to tighten ﬁrmly. 2. Remove the metal panel from the back of the shower unit. Use a Phillip’s screwdriver to remove each of the twelve screws holding it in place. 4.
PAGE 3
ALVIN OUTDOOR SHOWER INSTALLATION 5. Reattach the back panel to the shower unit. Before fastening, feed the unit’s water lines through the access hole on the panel, as shown. 7. Carefully move the shower unit into place. Adjust the leveling feet on the shower base until it is level. If desired, run a thin bead of clear silicone around the edge of the decorative metal escutcheon covering the mounting hardware. 6. Remove the plastic caps from each of the shower unit’s water lines.
PAGE 4
ALVIN OUTDOOR SHOWER INSTALLATION 9. Once the installation is complete, turn the shower unit on. Check for any leaks, and to ensure that hot and cold water are running appropriately.